' '
Deutsch | English    

Forschungsdatenbank PMU-SQQUID

Technical Note: Procedure for the calibration and validation of kilo-voltage cone-beam CT models.
Vilches-Freixas, G; Létang, JM; Brousmiche, S; Romero, E; Vila Oliva, M; Kellner, D; Deutschmann, H; Keuschnigg, P; Steininger, P; Rit, S;
Med Phys. 2016; 43(9):5199
Originalarbeiten (Zeitschrift)


Deutschmann Heinz
Kellner Daniel
Keuschnigg Peter
Steininger Philipp


The aim of this work is to propose a general and simple procedure for the calibration and validation of kilo-voltage cone-beam CT (kV CBCT) models against experimental data.
The calibration and validation of the CT model is a two-step procedure: the source model then the detector model. The source is described by the direction dependent photon energy spectrum at each voltage while the detector is described by the pixel intensity value as a function of the direction and the energy of incident photons. The measurements for the source consist of a series of dose measurements in air performed at each voltage with varying filter thicknesses and materials in front of the x-ray tube. The measurements for the detector are acquisitions of projection images using the same filters and several tube voltages. The proposed procedure has been applied to calibrate and assess the accuracy of simple models of the source and the detector of three commercial kV CBCT units. If the CBCT system models had been calibrated differently, the current procedure would have been exclusively used to validate the models. Several high-purity attenuation filters of aluminum, copper, and silver combined with a dosimeter which is sensitive to the range of voltages of interest were used. A sensitivity analysis of the model has also been conducted for each parameter of the source and the detector models.
Average deviations between experimental and theoretical dose values are below 1.5% after calibration for the three x-ray sources. The predicted energy deposited in the detector agrees with experimental data within 4% for all imaging systems.
The authors developed and applied an experimental procedure to calibrate and validate any model of the source and the detector of a CBCT unit. The present protocol has been successfully applied to three x-ray imaging systems. The minimum requirements in terms of material and equipment would make its implementation suitable in most clinical environments.

Useful keywords (using NLM MeSH Indexing)


Cone-Beam Computed Tomography*

Models, Theoretical*

Find related publications in this database (Keywords)

digital imaging
validation procedure
model calibration
x-ray spectra
detector response